(Press-News.org) This release is available in German.
As if controlled by an invisible hand, the welding head on the robot's arm races along the sheet metal parts. Where the laser hits, sparks fly and the metal glows red hot. The process lasts just a few seconds. The outer door panel and the door frame are now welded together perfectly. A thin weld seam extends along the join, but it can only be seen on one side. From the other side of the welded car door the join is invisible. This is a perfect weld – the kind every car manufacturer dreams of, because it could be used anywhere on the car body. Expensive work to hide the seam, such as folding the sheet metal or covering with trim would no longer be necessary.
Research scientists at the Fraunhofer Institute for Physical Measurement Techniques IPM in Freiburg have turned this car makers' dream into reality. 'Controlled partial penetration welding' is how experts refer to the process in which the laser does not burn right through all the sheets of metal – in contrast to full penetration welding, where a hole briefly forms in the melt pool. Instead, the weld seam is controlled to penetrate the lower sheet without damaging the bottom surface. Up to now, however, it was not possible to precisely control this type of welding and produce a seam that meets the requirements in respect of strength.
"As we do not weld through the sheet, basically we cannot see what we are doing," states Andreas Blug, project manager at Fraunhofer IPM, outlining the problem. But they found the solution using an innovative camera that generates temperature images. This enables the system to recognize how deep the laser has penetrated into the sheets. Where it burns into the metal, causing it to melt, the images show a hot region. If the bottom of the melt pool reaches the gap between the upper and lower sheets, the conduction of heat is interrupted and a cooler point can be seen. This is referred to as the full penetration hole. From the relative frequency of this full penetration hole the system calculates the penetration depth into the lower sheet. A software program then adapts the output of the laser to the specific requirements. "The process is closed loop controlled in real time," Blug explains. An extremely rapid camera system is needed for this – which is the key to Fraunhofer IPM's innovation. The system is based on cellular neural networks (CNN). A tiny processor is integrated in each pixel. They all work simultaneously and speed up the analysis of the individual images enormously, whereas in conventional image processing systems a few processors process the data consecutively. "In this way the system analyzes up to 14,000 images per second," says Blug. This compares with the usual rate of only 1,000 to 2,000 images per second.
Together with colleagues from the IFSW Institut für Strahlwerkzeuge at Stuttgart University and the Institut für Grundlagen der Elektrotechnik und Elektronik (IEE) at Dresden University of Technology, the Fraunhofer IPM research scientists have now developed a prototype which perfectly controls the surface welding process, offering car makers a further great benefit in comparison with full penetration welding: zinc does not vaporize on the bottom side of the weld. The corrosion problems encountered on galvanized car bodies are therefore a thing of the past.
INFORMATION:
Perfect welds for car bodies
2011-05-13
ELSE PRESS RELEASES FROM THIS DATE:
Water for Mongolia
2011-05-13
This release is available in German.
Mongolia is a country of contrasts – in summer boiling hot, in winter freezing cold; in the north damp, in the south bone dry. One million of its three million inhabitants live tightly packed together in the capital Ulaanbaatar, while the rest of the huge country is largely populated by nomads and their cattle. Providing a clean supply of drinking water across the entire country is a difficult challenge – beginning with the need to lay freeze-proof water pipes over an area of 1.5 million square kilometers. The people in the countryside ...
CAMH researcher discovers new gene that causes intellectual disability
2011-05-13
May 13, 2010 – (Toronto) – A new study involving Canada's Centre for Addiction and Mental Health (CAMH) has found a gene connected with a type of intellectual disability called Joubert syndrome.
CAMH Senior Scientist Dr. John Vincent has identified this gene that, when defective, leads to Joubert syndrome. This research is published in the 13 May 2011 issue of Cell.
This international study combined Dr. Vincent's gene mapping of a family with Joubert syndrome, with the use of a protein network map established by researchers at Genentech Inc., Stanford University and ...
The Importance of Putting Your Children First in Texas Divorce Cases
2011-05-13
Putting yourself first in a divorce proceeding is tempting. Whenever a husband (dad) and wife (mom) decide to dissolve their marriage, the heartache can be overwhelming. Of course, the torrent of emotional and legal problems multiplies exponentially when children are involved. Your adult problems will impact innocent and precious people who did not have a voice in your decision to give them two separate homes. Child custody (or child conservatorship as it is called in Texas) becomes one of the most important areas to resolve when finalizing the divorce details. With knowledge ...
Underage Alcohol Possession And Consumption In Virginia
2011-05-13
As the Centers for Disease Control describe it, "Alcohol use by persons under age 21 years is a major public health problem." While illegal for those under 21, the statistics indicate substantial use by many minors.
- 42% drank some amount of alcohol.
- 24% binge drank.
- 10% drove after drinking alcohol.
- 28% rode with a driver who had been drinking alcohol.
Virginia Laws Related to Underage Drinking
The Commonwealth of Virginia has very strict laws and severe punishment for underage possession and consumption of any alcohol.
- It is illegal for anyone ...
Common Birth Injuries and Their Causes
2011-05-13
Some birth injuries are relatively minor health concerns that heal within a few days or weeks, while others are significant medical events that can carry life-long consequences for children and their parents. Sometimes no one is at fault for a birth injury that occurred during labor or delivery. However, other birth injuries result from the negligence of doctors, nurses or other medical-care providers.
Reduced Oxygen
Reduced oxygen is one of the main causes of brain injuries during labor and delivery. When a baby's oxygen supply is reduced or blocked, brain damage ...
Florida Changes Its Slip-and-Fall Law
2011-05-13
The state of Florida has made it significantly more difficult for plaintiffs to prevail in slip-and-fall cases.
If you or a member of your family has suffered an injury, contact a slip and fall attorney for an evaluation of the facts of the case.
The Old Law Compared to the New Law
The old premises liability law simply required plaintiffs to prove that an accident had taken place. The new law, which went into effect on July 1, requires plaintiffs to prove that a defendant knew of the conditions that resulted in the accident.
Plaintiffs have another avenue to ...
Possible Recognition of Parental Alienation Syndrome Controversial
2011-05-13
As everyone knows, divorces can often be contentious. Add children to the mix, and it can heighten the animosity, as both parents strive to do what they feel is best for the children. Sometimes these efforts boil over into accusations that the other parent is "bad" in some way -- eventually causing the child to share one parent's dislike for the other. In extreme cases, children have become unfairly estranged from one of their parents as a result.
Over the past 30 years, a name has emerged for this sort of situation -- parental alienation syndrome. Those who ...
Software reveals critical crop growth stages
2011-05-13
This release is available in Spanish.
U.S. Department of Agriculture (USDA) agronomist Greg McMaster has developed computer software that tells farmers when to spray pesticides. McMaster works at the Agricultural Research Service (ARS) Agricultural Systems Research Unit in Fort Collins, Colo. ARS is USDA's principal intramural scientific research agency.
The software, called "PhenologyMMS (Modular Modeling System)," predicts the timing of plant growth stages so Central Great Plains farmers and ranchers can know how their crop is progressing and when to apply pesticides, ...
MIT control theory research: How to control complex networks
2011-05-13
CAMBRIDGE, Mass. -- At first glance, a diagram of the complex network of genes that regulate cellular metabolism might seem hopelessly complex, and efforts to control such a system futile.
However, an MIT researcher has come up with a new computational model that can analyze any type of complex network — biological, social or electronic — and reveal the critical points that can be used to control the entire system.
Potential applications of this work, which appears as the cover story in the May 12 issue of Nature, include reprogramming adult cells and identifying new ...
Adding Insult to Injury: California Cities Charging "Crash Tax" to Car Accident Victims
2011-05-13
If you've never been in a car accident count perhaps you should count yourself lucky. Motor vehicle accident statistics suggest that one in four people will be involved in a car accident at least once during their lifetimes. If you are one of those four people already, you know the inconvenience that even a minor fender-bender can bring. Between police reports, conversations with insurance companies, body shop estimates and medical bills, being involved in a car accident is not a simple or cheap matter.
And expenses stemming from car accidents are not just limited to ...